Getting the sink controller to be useful

In my last post, I had created a setup with a single switch that only had full-blast warm or full off. This doesn't encompass the full range of use for my bathroom sink, so I'd like to flesh that out a little more. I also found what I thought was the perfect power supply, but for some reason everything behaved very erratically, possibly due to de-coupling. This means that I may need to put capacitors between my power supply and my servos and/or arduino. However, this isn't a critical issue at the moment, as I can always just use the power setup I had previously. What's important at the moment is getting the apparatus to be useful.

If I can make it easier to get the right temperature using the device than it is manually, I will consider the project successful. I think that by having several of the most common settings rigged to buttons, I'll be able to achieve this.

I bought a breadboard and a bunch of clicky buttons. Each button will be one setting. After talking with Kerry, my first iteration of this idea will have the following settings:

• Full cold - filling water bottles, rinsing a glass
• Medium cold - putting a small amount of water in a glass
• Low cold - wetting a toothbrush
• Medium warm (full-blast hot to make it heat up quickly, then reduce)
• Off

I'll need 5 pins as inputs, and I'll need to make a "state" that changes when each pin is activated. I had the issue before where pins that weren't getting an input would return random values, but I've just read about enabling the Arduino's internal pull-up for digital pins! This means I don't need to waste time adding pull-up resistors to all my pins. Thank goodness. Here I go!